Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
On the back there is a slider that locks the back cover on slide this over to unlock it.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the battery and sim card as well as the micro sd if one.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the 3 torx screws on both sides.
-
Now remove one more torx screw on the bottom.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the pry tool and insert in between the black and white plastic. Slide across all sides to unlock the clips holding it together.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the the back case (white section) revealing the logic board.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the pry tool and detach the digitizer cable and LCD cable from the board.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Lift the logic board out of the phone revealing the LCD.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use pry tool to gently lift the LCD out of the phone revealing the digitizer.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Now all that is left is the digitizer frame holding the digitizer.
-
To remove a broken digitizer heat the front edges of this frame to soften the digitizer adhesive and pry away from the frame.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Thats it now just follow these steps in reverse to put your phone back together.
-
5 commentaires
Brilliant! Many thanks. Things to watch: the volume rocker and on switch tend to fall out, so secured them to the back with a little bit of masking tape while I reassembled. Helped to slightly lift one end of the motherboard so the case can go around the USB power socket. After that it fits back together with only minor persuasion.
Hi,
my Search "button" stop lightning. The other 3 "buttons" are ok.
Did someone know the reason?
Thank you!
Help! I bought a t5 torx screwdriver to open my motorola and the screwdriver seems too smal! Wtf? Many dismount video says that this is a t5 model, I don't understand...
can you mark ram on that board ?