Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Prepare an iOpener and lay it over the rear case to soften the adhesive on securing the rear case to the phone.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use a plastic opening tool to pry the rear case off of the rest of the device.
-
Remove the rear case.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the four Torx T5 screws securing the midframe plate.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use a Jimmy to pry under the speaker and lift to remove it.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the point of a spudger to pop up the battery connector.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Fold the wireless charging coil away from the battery.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use a spudger to gently pry the battery up from the rest of the device.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the four Torx T5 screws securing the lower antenna board to the motherboard.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the SIM card holder/volume button rocker.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Carefully lift up the motherboard to expose the display connector.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the flat end of a spudger to flip up the retaining flap on the display ZIF connector.
-
Pull the display ribbon cable free of the connector.
-
Annulation : je n'ai pas terminé ce tutoriel.
16 autres ont terminé cette réparation.
8 commentaires
This has a bunch of unecessary steps and is missing so,e just kinda bricked my phone thanks to this
Yep. It repeats a bunch of steps, and seems to switch from replacing the display to replacing the motherboard. :(
has anyone ever had the buttons break on this phone? i know on my old droid maxx one little mistake when putting the board in the metal frame was enough to break the volume buttons.
You don’t need to remove the battery from the board…the whole thing comes up as one.