Introduction

If one needs access to the inner components of the Droid X or they are needing to replace the rear plastic of the device, this guide will walk a reader through the necessary steps.

Pièces

Aucune pièce nécessaire.

Locate the power button at the top of the phone.  Depress power button for 2 seconds until a menu appears.
  • Locate the power button at the top of the phone. Depress power button for 2 seconds until a menu appears.

Ajouter un commentaire

Once the menu appears, select the "power off" option.  Wait until the phone is completely off.
  • Once the menu appears, select the "power off" option. Wait until the phone is completely off.

Ajouter un commentaire

  • Place thumb on the back cover, and push down towards the bottom of the device. Once the cover releases, pull it away from the phone and set it aside.

Ajouter un commentaire

  • Find the yellow pull tab located in the upper left corner. Pull the tab until the battery dislodges. Grab the battery by the raised edge, and remove it from the case.

Ajouter un commentaire

  • The battery has been successfully removed.

Ajouter un commentaire

  • Remove the micro SD card from its connector.

Ajouter un commentaire

  • Locate the seam between the back case and the end cover on the top edge of the phone.

  • Use the plastic opening tool to detach the two clips by wedging the tool into the right side of the seam and moving right to left. Once the cover comes off set it aside

Ajouter un commentaire

  • Repeat step 2 on the bottom cover.

Ajouter un commentaire

  • Use a T5 Torx screwdriver to remove the screws in each corner of the phone.

  • The screws are very small so make sure not to lose them.

Ajouter un commentaire

  • Flip the phone over and locate the screw on the middle of the left side. Unscrew it using the T5 Torx screwdriver and set it aside.

Ajouter un commentaire

  • Identify the screw located in the bottom right corner of the battery case. Remove the screw with a T5 (or in some cases T6) torx screwdriver and set it aside.

Ajouter un commentaire

  • Locate the seam along the right edge of the phone. Use the prying tool to disconnect the two clips along the edge.

Ajouter un commentaire

  • Locate the two clips on the inside of the case and use the spudger tool to detach them from the case. To detach each clip, use the sharp end to press the small, black plastic in the center of the clip.

Ajouter un commentaire

  • After the clips are detached, remove the back case and set it aside.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Sam Johnston

Membre depuis le 03/10/2012

486 Réputation

4 tutoriels rédigés

Équipe

Cal Poly, Team 18-40, Regan Fall 2012 Membre de l'équipe Cal Poly, Team 18-40, Regan Fall 2012

CPSU-REGAN-F12S18G40

3 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 6

Total : 727