Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove camera&flashlight metal cover. Use tweezers to cut strong adhesives underneath.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Undo 3 screws by T4 Torx screwdriver.
-
Take away plastic securing part.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Heat up the LCD screen for a while.
-
Then with the help of suction cup, insert guitar picks to open a gap. Slide guitar picks or plastic opening tool to cut strong adhesives.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Release LCD screen connector firstly.
-
Remove LCD screen.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Undo 14 screws by T4 Torx screwdriver
-
Pry up motherboard assembly.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Release battery flex connector.
-
Separate motherboard assembly from back cover assembly.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Undo 3 screws here.
-
Use spudger to cut adhesives and pry the SIM&SD card reader board, then remove it.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use spudger to cut adhesive and pry the battery up.
-
Annulation : je n'ai pas terminé ce tutoriel.
18 autres ont terminé cette réparation.
7 commentaires
Could you guys tell me if the main speaker, at the bottom, has a special protection agains water spills, like a membrane or so, or is it pretty fine too spill water there?
Wi fi not trun on ..moto g3
Thanks. ......................