Aller au contenu principal

Introduction

This guide will show you how to install the Motorola Razr V3 camera. You may need to install a new camera if the camera doesn't show any picture or otherwise does not work.

Vidéo d'introduction

  1. Remove the back cover by pressing down the silver button. Pull the cover away from the phone.
    • Remove the back cover by pressing down the silver button.

    • Pull the cover away from the phone.

  2. Remove the battery by pushing down on the top and pulling it away from the phone, similar to the cover. Remove the battery by pushing down on the top and pulling it away from the phone, similar to the cover.
    • Remove the battery by pushing down on the top and pulling it away from the phone, similar to the cover.

  3. Use tweezers to pry off all four rubber screw covers from the inside face, pulling them towards you.
    • Use tweezers to pry off all four rubber screw covers from the inside face, pulling them towards you.

    • Our phone is missing the two left screw covers, be careful not to lose yours too!

  4. Batteries pour ordinateurs portables

    Batteries pour toutes les grandes marques d'ordinateurs portables. Qualité assurée par notre garantie.

    Acheter maintenant

    Batteries pour ordinateurs portables

    Batteries pour toutes les grandes marques d'ordinateurs portables. Qualité assurée par notre garantie.

    Acheter maintenant
  5. Remove the four T5 Torx screws that were underneath the rubber covers.
    • Remove the four T5 Torx screws that were underneath the rubber covers.

  6. Use the plastic opening tool to pry the top cover away from the phone.
    • Use the plastic opening tool to pry the top cover away from the phone.

    • The side buttons on the phone may fall out when the top cover is separated from the phone. They can easily be put back by placing them in their original spot.

  7. Use tweezers to flip up the ZIF tab on the camera ribbon cable socket. Gently pull the camera ribbon cable out of the ZIF socket.
    • Use tweezers to flip up the ZIF tab on the camera ribbon cable socket.

    • Gently pull the camera ribbon cable out of the ZIF socket.

  8. Using a pair of tweezers gently grab and remove the camera from the phone.
    • Using a pair of tweezers gently grab and remove the camera from the phone.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Christian

Membre depuis le 18/04/2013

149 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 3-46, Amido Spring 2013 Membre de l'équipe Cal Poly, Team 3-46, Amido Spring 2013

CPSU-AMIDO-S13S3G46

4 membres

8 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 5

Total : 1,255