Réparez vos affaires Communauté Boutique

Motorola V557 Screen Replacement

Introduction

The screen is a common breaking point for cellular phones, and can be replaced to repair an unusable phone.

Ce dont vous avez besoin

  1. Motorola V557 Screen Replacement, Faceplate: étape 1, image 1 de 3 Motorola V557 Screen Replacement, Faceplate: étape 1, image 2 de 3 Motorola V557 Screen Replacement, Faceplate: étape 1, image 3 de 3

    • Remove the four rubber stoppers from around the screen with a pin to reveal four screws.

    Modifier

  2. Motorola V557 Screen Replacement: étape 2, image 1 de 2 Motorola V557 Screen Replacement: étape 2, image 2 de 2

    • Remove the four 3.8 mm T-6 Torx screws.

    Modifier

  3. Motorola V557 Screen Replacement: étape 3, image 1 de 2 Motorola V557 Screen Replacement: étape 3, image 2 de 2

    • Separate the cover from the edges using a plastic opening tool.

    Modifier

  4. Motorola V557 Screen Replacement: étape 4, image 1 de 2 Motorola V557 Screen Replacement: étape 4, image 2 de 2

    • With the edges separated, close the phone and lift off the faceplate with your fingers.

    Modifier

  6. Motorola V557 Screen Replacement, Camera: étape 5, image 1 de 1

    • Gently peel off the plastic film from the metal plate above the camera lens as shown.

    Modifier

  7. Motorola V557 Screen Replacement: étape 6, image 1 de 2 Motorola V557 Screen Replacement: étape 6, image 2 de 2

    • Insert the spudger into the slots marked and gently pry upwards to remove the metal cover.

    • Repeat the previous bullet for the two corresponding tabs on the opposite side of the phone.

    Modifier

  8. Motorola V557 Screen Replacement: étape 7, image 1 de 2 Motorola V557 Screen Replacement: étape 7, image 2 de 2

    • Lift and peel back the tape attaching metal casing to body of the phone.

    • Gently lift the metal cover and remove to expose the circuit board.

    Modifier

  9. Motorola V557 Screen Replacement: étape 8, image 1 de 2 Motorola V557 Screen Replacement: étape 8, image 2 de 2

    • Using a plastic opening tool, pry or lift open the pink door shown.

    • After the door is open, gently pull on the ribbon cable's corner to separate it from the board.

    • Work out the ribbon cable's end slowly and gently to avoid damaging the pink door port.

    Modifier

  10. Motorola V557 Screen Replacement: étape 9, image 1 de 3 Motorola V557 Screen Replacement: étape 9, image 2 de 3 Motorola V557 Screen Replacement: étape 9, image 3 de 3

    • Use a plastic opening tool to dislodge and remove the rubber camera cover.

    Modifier

  11. Motorola V557 Screen Replacement: étape 10, image 1 de 2 Motorola V557 Screen Replacement: étape 10, image 2 de 2

    • Lift the top ribbon cable, with camera attached, up and away from the rest of the phone.

    Modifier

  12. Motorola V557 Screen Replacement, Screen: étape 11, image 1 de 3 Motorola V557 Screen Replacement, Screen: étape 11, image 2 de 3 Motorola V557 Screen Replacement, Screen: étape 11, image 3 de 3

    • Pull the ribbon cable up and out of the way to get access to the circuit board-screen unit.

    • Using a plastic opening tool, gently pry and remove the circuit board-screen unit in both screens.

    Modifier
Conclusion

To reassemble your device, follow these instructions in reverse order.

Auteur

avec 7 autres contributeurs

Blair Frandeen

Membre depuis le 10/02/10

19 Réputation

4 tutoriels rédigés

Badges: 5

+ 2 badges supplémentaires

Équipe

Cal Poly, Team 7-50, Amido Fall 2010 Membre de l'équipe Cal Poly, Team 7-50, Amido Fall 2010

CPSU-AMIDO-F10S7G50

4 membres

24 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 1

Total : 2,735