Introduction

Removing the speaker requires the removal of the motherboard, which requires nearly a full dis-assembly of the phone.

Pièces

Aucune pièce nécessaire.

Place thumb on the rubber tab on the lower back of the phone.
  • Place thumb on the rubber tab on the lower back of the phone.

  • Push away from the phone to release back panel.

Ajouter un commentaire

Lift the back panel of the phone to expose battery (not shown here).
  • Lift the back panel of the phone to expose battery (not shown here).

Ajouter un commentaire

  • Pull antenna up, away from the phone, to reveal two of six screws.

Ajouter un commentaire

  • Unscrew all six 5.4 mm screws on the back side of the phone using the T-6 screwdriver bit.

Ajouter un commentaire

  • Gently separate the front and back sides of the phone.

  • Be careful not to break or bend the ribbon cables.

Ajouter un commentaire

  • Detach the first ribbon cable by unplugging it from the logic board.

Ajouter un commentaire

  • Gently remove the side button by pulling the buttons away from the phone.

Ajouter un commentaire

  • Grab the tab at the bottom of the metal plate, and pull to remove the plate from the phone.

Ajouter un commentaire

  • Slightly bend the phone frame to expose microphone protrusion.

  • Gently remove microphone using your fingers.

Ajouter un commentaire

  • Once the microphone has been removed, remove the connecting piece

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Haley S

Membre depuis le 11/03/2013

1 Réputation

4 tutoriels rédigés

Équipe

Clemson, Team 13-6, Benson Spring 2013 Membre de l'équipe Clemson, Team 13-6, Benson Spring 2013

CLEM-BENSON-S13S13G6

3 membres

10 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 102