Introduction

This guide will install the motherboard, which will require removal of the battery and disconnection of the speaker and microphone ribbon cables.

Pièces

Aucune pièce nécessaire.

Place thumb on the rubber tab on the lower back of the phone.
  • Place thumb on the rubber tab on the lower back of the phone.

  • Push away from the phone to release back panel.

Ajouter un commentaire

Lift the back panel of the phone to expose battery (not shown here).
  • Lift the back panel of the phone to expose battery (not shown here).

Ajouter un commentaire

  • Pull the antenna up to reveal two of the six screws.

Ajouter un commentaire

  • Unscrew all six screws on the back side of the phone using a T-6 bit.

Ajouter un commentaire

  • Gently separate the front and back sides of the phone, as shown in the picture.

  • Be careful not to break or bend the ribbon cables.

Ajouter un commentaire

  • Detach the first ribbon cable by unplugging it from the motherboard.

Ajouter un commentaire

  • Detach the speaker ribbon cable from the motherboard.

Ajouter un commentaire

  • Remove the motherboard from the front half of the phone by gently shaking it loose. It should come out with little to no trouble.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Ariel

Membre depuis le 11/03/2013

16 Réputation

4 tutoriels rédigés

Équipe

Clemson, Team 13-6, Benson Spring 2013 Membre de l'équipe Clemson, Team 13-6, Benson Spring 2013

CLEM-BENSON-S13S13G6

3 membres

10 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 87