Réparez vos affaires Communauté Boutique

Nerf N-Strike Elite Strongarm Outer Shell Replacement

Conditions préalables uniquement
Ce tutoriel est uniquement destiné à être utilisé comme prérequis d'autres tutoriels. Il ne se suffit pas à lui-même.

Introduction

If your Strongarm Nerf gun isn't behaving the way it should, one of the first steps in troubleshooting will be to open it up for disassembling. Thankfully, this isn't a hard task, and boils down to locating the right screws.

Ce dont vous avez besoin

  1. Nerf N-Strike Elite Strongarm Outer Shell Replacement, Outer Shell: étape 1, image 1 de 2 Nerf N-Strike Elite Strongarm Outer Shell Replacement, Outer Shell: étape 1, image 2 de 2

    • Lay the Nerf Strongarm on its side, left side facing up.

    Modifier

  2. Nerf N-Strike Elite Strongarm Outer Shell Replacement: étape 2, image 1 de 2 Nerf N-Strike Elite Strongarm Outer Shell Replacement: étape 2, image 2 de 2

    • Locate the 12 Philips head screws and remove them: Head Diameter= 4.3mm, Thread Pitch= 1mm, Screw Length= 8mm

    Modifier

  4. Nerf N-Strike Elite Strongarm Outer Shell Replacement: étape 3, image 1 de 1

    • Before removing the cover, make sure to first remove the cover for the cocking mechanism. The top half is freely removable.

    • The other half of the cocking mechanism is connected with a spring which may slide off the blaster. Be advised this is normal but worth watching to avoid damaging the spring.

    Modifier

  5. Nerf N-Strike Elite Strongarm Outer Shell Replacement: étape 4, image 1 de 1

    • At this time, remove the blaster cover to reveal its internals.

    • If the blaster is resting on its side, the barrel may shift slightly as it is leaning on itself (seen in the image). This is normal but should be handled with care to keep the blaster together.

    Modifier

  6. Nerf N-Strike Elite Strongarm Outer Shell Replacement: étape 5, image 1 de 1

    • Once the screws have been removed, lift the top half of the gun off.

    • Notice, the gray colored piece must be removed first in order for the larger half to be removed.

    • Take care and try not to lose any smaller pieces as you open it up.

    • Locking tab for attachments.

    Modifier
Conclusion

To reassemble your device, follow these instructions in reverse order.

Auteur

avec 4 autres contributeurs

Giancarlo Villar

Membre depuis le 08/27/15

540 Réputation

1 tutoriel rédigé

Badges: 10

+ 7 badges supplémentaires

Équipe

USF Tampa, Team 5-4, Blackwell Fall 2015 Membre de l'équipe USF Tampa, Team 5-4, Blackwell Fall 2015

USFT-BLACKWELL-F15S5G4

4 membres

12 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 182