Introduction
This guide is needed to replace the Micro-USB port if the Nest Dropcam Pro is plugged in but not receiving power. Make sure the device is unplugged before opening.
Ce dont vous avez besoin
-
-
Press in the mounting clips on each side of the case to remove the camera from the mount.
-
-
-
-
Insert a spudger tool under the micro-USB port and lift to separate the motherboard from the back case.
-
-
-
Using a soldering station and desoldering braid, desolder the four points surrounding the Micro-USB port.
-
Lift the Micro-USB port away from the motherboard.
Where do you buy the Micro-usb port to replace damaged one?
I have the same question. My connector is broken and I would like to salvage the camera if possible!
Hello. Any idea where I can purchase a new motherboard for my dropcam pro?
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
4 autres ont terminé cette réparation.
4 commentaires
I don't have the soldering tools but I used lazerbond to reattach the old port. I hope all the conductors are touching their counter parts. I haven't plugged it back in yet. Wish me luck.
Did it work for you?
Where can you order the micro-usb charge port for this cam?
Not sure where you get them but according to one site it uses a Micro USB 2.0 Type B Receptacle.