Réparez vos affaires Communauté Boutique

Nikon COOLPIX S610c Motherboard Replacement

Introduction

If camera no longer works at all, then it might be time to replace the motherboard. Follow this guide to remove the motherboard from your camera.

Ce dont vous avez besoin

  1. Nikon COOLPIX S610c Motherboard Replacement, Rear Casing: étape 1, image 1 de 1

    • Remove the three 3x3mm screws attached to the rear casing.

    Modifier

  2. Nikon COOLPIX S610c Motherboard Replacement: étape 2, image 1 de 1

    • The panel can be identified by the wifi logo on its upper half on the camera's side.

    • Remove the 5x3mm screw holding down the panel on the side closest to the lens.

    Modifier

  3. Nikon COOLPIX S610c Motherboard Replacement: étape 3, image 1 de 1

    • Pry the panel off from the bottom using your fingernail.

    Modifier

  4. Nikon COOLPIX S610c Motherboard Replacement: étape 4, image 1 de 1

    • Remove the 3x2mm screw underneath the panel near the top of the camera.

    Modifier

  5. Nikon COOLPIX S610c Motherboard Replacement: étape 5, image 1 de 2 Nikon COOLPIX S610c Motherboard Replacement: étape 5, image 2 de 2

    • Remove the 4x3mm on the opposite side near the selector wheel.

    • Remove the 2x2mm and 3x2mm screws underneath the a/v flap.

    Modifier

  6. Nikon COOLPIX S610c Motherboard Replacement: étape 6, image 1 de 2 Nikon COOLPIX S610c Motherboard Replacement: étape 6, image 2 de 2

    • Pry the back panel away from the body of the camera, using the space you just opened up.

    • Be careful not to damage the ribbon cable on the opposite end of the camera.

    • A small piece of the frame of the camera may fall off, but it can be easily put back into place during reassembly.

    Modifier

  8. Nikon COOLPIX S610c Motherboard Replacement: étape 7, image 1 de 2 Nikon COOLPIX S610c Motherboard Replacement: étape 7, image 2 de 2

    • Pry up the plastic ribbon connectors on the body of the camera to release the ribbon cables.

    • The center connector is detached by flipping the black latch up and away from the center of the camera.

    • The smaller connector is detached by flipping the tan latch up and away from the edge of the camera.

    Modifier

  9. Nikon COOLPIX S610c Motherboard Replacement, Front Casing: étape 8, image 1 de 1

    • Remove the three 3x3mm screws that attach the front casing to the bottom.

    Modifier

  10. Nikon COOLPIX S610c Motherboard Replacement: étape 9, image 1 de 1

    • Remove the two 3x2 screws and two 3.5x2.5 screws attaching the rear panel to the motherboard.

    Modifier

  11. Nikon COOLPIX S610c Motherboard Replacement: étape 10, image 1 de 2 Nikon COOLPIX S610c Motherboard Replacement: étape 10, image 2 de 2

    • Lift the back panel off the motherboard.

    • Be careful not to damage the ribbon cable that attaches the mother board to the rear panel.

    Modifier

  12. Nikon COOLPIX S610c Motherboard Replacement: étape 11, image 1 de 2 Nikon COOLPIX S610c Motherboard Replacement: étape 11, image 2 de 2

    • Detach the ribbon cable from the motherboard by flipping up the latch on the ribbon connector.

    • Note that the white ribbon connector latch flips away from the ribbon cable.

    Modifier

  13. Nikon COOLPIX S610c Motherboard Replacement: étape 12, image 1 de 2 Nikon COOLPIX S610c Motherboard Replacement: étape 12, image 2 de 2

    • Remove the final 4x3mm screw at the top of the camera near the lens.

    Modifier

  14. Nikon COOLPIX S610c Motherboard Replacement: étape 13, image 1 de 2 Nikon COOLPIX S610c Motherboard Replacement: étape 13, image 2 de 2

    • Pry the front casing away from the body of the camera.

    • Be careful not to damage the wires that attach the front panel to the motherboard.

    • Short the leads on the capacitor near the flash to avoid a nasty shock when separating the casing from the body.

    Modifier

  15. Nikon COOLPIX S610c Motherboard Replacement: étape 14, image 1 de 1

    • Unscrew the three 3x2mm screws that attach the cables to the front casing.

    Modifier

  16. Nikon COOLPIX S610c Motherboard Replacement, Lens Assembly: étape 15, image 1 de 2 Nikon COOLPIX S610c Motherboard Replacement, Lens Assembly: étape 15, image 2 de 2

    • Pry up the ribbon connector that connects the ribbon cable to the lens assembly.

    • Take note that the ribbon connector pulls away from the ribbon.

    Modifier

  17. Nikon COOLPIX S610c Motherboard Replacement, Motherboard: étape 16, image 1 de 1

    • Once the lens assembly has been removed, the mother board cannot be disassembled any further.

    Modifier
Conclusion

To reassemble your device, follow these instructions in reverse order.

Auteur

avec 4 autres contributeurs

Kevin Backers

Membre depuis le 01/26/12

301 Réputation

4 tutoriels rédigés

Badges: 6

+ 3 badges supplémentaires

Équipe

Cal Poly, Team 9-5, Regan Winter 2012 Membre de l'équipe Cal Poly, Team 9-5, Regan Winter 2012

CPSU-REGAN-W12S9G5

5 membres

12 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 3

Total : 511