Introduction

If the screen does not power on, even when the camera itself is powered on, the LCD screen could be broken. This guide will show the proper instructions for replacing the screen.

Pièces

Aucune pièce nécessaire.

Remove the three 4 mm screws from the bottom of the camera using a #00 Phillips screwdriver.
  • Remove the three 4 mm screws from the bottom of the camera using a #00 Phillips screwdriver.

  • Remove the single 3.5 mm screw from the bottom of the camera using a #00 Phillips screwdriver.

Ajouter un commentaire

With the bottom of the camera facing you, slide the latch on the compartment to the left.
  • With the bottom of the camera facing you, slide the latch on the compartment to the left.

  • Swing the battery compartment door open.

  • Remove the 3.5 mm screw from the inside with a #00 Phillips screwdriver.

Ajouter un commentaire

  • With the screen facing you, locate the two 3.5 mm screws on the left face of the camera. Remove them using a #00 Phillips screwdriver.

Ajouter un commentaire

  • With the screen facing you, locate the three 3.5 mm screws on the right face of the camera. Remove them with a #00 Phillips screwdriver.

  • Two of the screws are located under the port tabs.

Ajouter un commentaire

  • Locate the crease where the case comes together.

  • Using a plastic prying tool, pry at the line to remove the camera case.

  • It may take several attempts to remove the case. Remember to pry at all the crease locations on the camera, and not just one spot.

Ajouter un commentaire

  • Slide the yellow navigation panel to the right so that it can be lifted up.

  • It may take a little pressure to get the panel to separate.

  • Be careful not to damage the ribbon cable that is still attached to the camera.

Ajouter un commentaire

  • Remove the three 4 mm screws with a #00 Phillips screwdriver.

Ajouter un commentaire

  • Locate the magnet and copper tape on the left side of the camera.

  • Gently pull the copper tape off of the metal plate.

  • The copper tape is attached with some glue, so a little force will be needed to detach it.

Ajouter un commentaire

  • Lift the screen up and swing it to the right, exposing the circuit board underneath.

  • The navigation panel should still be attached to the circuit board with a ribbon cable as indicated in red.

  • Detach the ribbon cable that is connecting the LCD screen and the circuit board.

I had to use some Goo Gone to loosen the glue between the old screen and the aluminum mounting plate.

Tommy Evans - Réponse

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 autre(s) ont terminé cette réparation.

Jim Bui

Membre depuis le 20/01/2015

775 Réputation

6 tutoriels rédigés

Équipe

USF Tampa, Team 1-4, Blackwell Winter 2015 Membre de l'équipe USF Tampa, Team 1-4, Blackwell Winter 2015

USFT-BLACKWELL-W15S1G4

4 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 7

30 derniers jours : 45

Total : 2,137