Introduction

Use this guide to replace the back cover.

  1. Remove the four 3.0mm screws on the bottom of the camera.
    • Remove the four 3.0mm screws on the bottom of the camera.

  2. Remove the two 3.0mm screws on the left side of the camera near the memory card compartment.
    • Remove the two 3.0mm screws on the left side of the camera near the memory card compartment.

    • Remove the two 3.0mm screws on the right side of the camera.

    • Carefully open the back cover. Take care as there are connectors still attached.

    • Disconnect the cable by pulling the head upward along the green circuit board. If you only are changing the LCD, skip this step.

    • Disconnect the ribbon cable by grabbing the two handles and pulling it directly out of the socket. If you are only changing LCD, skip this step.

    • The back cover will be disconnected from the camera

Conclusion

To reassemble your device, follow these instructions in reverse order.

Kaky Payne

Membre depuis le 17/04/2012

58 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team 12-38, Regan Spring 2012 Membre de l'équipe Cal Poly, Team 12-38, Regan Spring 2012

CPSU-REGAN-S12S12G38

4 membres

5 tutoriels rédigés

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 6

Total : 920