Introduction

Use this guide to replace the front cover.

Pièces

Aucune pièce nécessaire.

  1. Remove the four 3.0mm screws on the bottom of the camera.
    • Remove the four 3.0mm screws on the bottom of the camera.

  2. Remove the two 3.0mm screws on the left side of the camera near the memory card compartment.
    • Remove the two 3.0mm screws on the left side of the camera near the memory card compartment.

  3. Remove the two 3.0mm screws on the right side of the camera.
    • Remove the two 3.0mm screws on the right side of the camera.

  4. %Livraison gratuite pour toute commande supérieure à 100,00 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique

    Vous avez déjà réparé quelque chose ? Vous êtes un génie.

    Partagez votre réparation avec le hashtag #ImAGenius

    Nous sommes tous des génies

    Partagez votre réparation avec le hashtag #ImAGenius

  5. Carefully open the back cover. Take care as there are connectors still attached.
    • Carefully open the back cover. Take care as there are connectors still attached.

  6. Disconnect the cable by pulling the head upward along the green circuit board. If you only are changing the LCD, skip this step.
    • Disconnect the cable by pulling the head upward along the green circuit board. If you only are changing the LCD, skip this step.

  7. Disconnect the ribbon cable by grabbing the two handles and pulling it directly out of the socket. If you are only changing LCD, skip this step.
    • Disconnect the ribbon cable by grabbing the two handles and pulling it directly out of the socket. If you are only changing LCD, skip this step.

    • The back cover will be disconnected from the camera

  8. Be careful of metallic parts which are loose and will fall out.
    • Be careful of metallic parts which are loose and will fall out.

    • Remove the two 2.5mm screws on the bottom of the left side, after having removed the back cover.

  9. Remove the two 3.0mm screws on the right side of the camera.
    • Remove the two 3.0mm screws on the right side of the camera.

  10. Remove front cover.
    • Remove front cover.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Kaky Payne

Membre depuis le 17/04/2012

58 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team 12-38, Regan Spring 2012 Membre de l'équipe Cal Poly, Team 12-38, Regan Spring 2012

CPSU-REGAN-S12S12G38

4 membres

5 tutoriels rédigés

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 3

Total : 1,074