Introduction

This guide will outline how to remove a dead battery, as well as how to properly install a new one.

Outils

Aucun outil requis.

  • At the top of the camera, turn the Mode dial to OFF.

Ajouter un commentaire

Lay the top of the camera down on a flat surface so that the informational tag and battery compartment are accessible.
  • Lay the top of the camera down on a flat surface so that the informational tag and battery compartment are accessible.

  • To open the battery compartment, push the latch underneath the word BATTERY to the left.

Ajouter un commentaire

  • Lift the battery compartment cover and remove the old battery.

Ajouter un commentaire

  • Insert the new battery as shown on the underside of the compartment lid.

Ajouter un commentaire

  • Flip the battery compartment lid closed and push the latch to the right.

Ajouter un commentaire

  • Flip the camera so that the bottom rests on the table.

  • Turn the Mode dial to [A] to verify that the control panel shows a full power indicator.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Cory Layman

Membre depuis le 04/10/2011

89 Réputation

3 tutoriels rédigés

Équipe

UW Stout, Team 1-5, Zhou Fall 2011 Membre de l'équipe UW Stout, Team 1-5, Zhou Fall 2011

UWSTOUT-ZHOU-F11S1G5

5 membres

3 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 6

Total : 1,362