Aller au contenu principal

Introduction

This guide will walk you through the necessary steps to remove the back panel of the Nikon Coolpix E5700.

Pièces

Aucune pièce spécifiée.

  1. Use your finger tip to slide the battery release tab toward the battery symbol on the E5700. Open the battery door.
    • Use your finger tip to slide the battery release tab toward the battery symbol on the E5700.

    • Open the battery door.

  2. Pull the battery out of the E5700.
    • Pull the battery out of the E5700.

    • It may be necessary to wiggle the battery while pulling to free it from its pocket in the case.

  3. Turn to the bottom of the camera.
    • Turn to the bottom of the camera.

    • Remove the two Phillips screws located directly below the back monitor

  4. Fix Kits pour batteries d'iPhone

    Seulement $29.99

    Buy Now

    Fix Kits pour batteries d'iPhone

    Seulement $29.99

    Buy Now
  5. Turn the camera to the side with the memory card slot and open the compartment for the CF card. Remove the top two Phillips screws closest to the back panel.
    • Turn the camera to the side with the memory card slot and open the compartment for the CF card.

    • Remove the top two Phillips screws closest to the back panel.

  6. Turn to the back of the camera.
    • Turn to the back of the camera.

    • Remove the top most Phillips screw on the back panel.

  7. Turn to the last side of the back panel.
    • Turn to the last side of the back panel.

    • Remove the Phillips screw below the eyepiece.

    • Remove the Phillips screw located above the speaker.

  8. Gently begin to remove the back panel. Caution: There are two bundles of wires connecting the back panel to the camera. Be sure not to pull too hard and yank these out.
    • Gently begin to remove the back panel.

    • Caution: There are two bundles of wires connecting the back panel to the camera. Be sure not to pull too hard and yank these out.

  9. Now gently unplug the two wires at the bottom of the panel. Now gently unplug the two wires at the bottom of the panel.
    • Now gently unplug the two wires at the bottom of the panel.

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Raana

Membre depuis le 12/04/2011

78 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 24-58, Amido Spring 2011 Membre de l'équipe Cal Poly, Team 24-58, Amido Spring 2011

CPSU-AMIDO-S11S24G58

4 membres

9 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 1,717