Introduction

This casing not only protects the lense, but acts as the decorative silver plastic running around the side of the camera, and holds the buttons on top.

It may need replacement in the event a button is broken, or any of the casing is cracked while using the camera.

Pièces

Aucune pièce nécessaire.

Slide the battery door open with a finger or thumb and release it so the door opens.
  • Slide the battery door open with a finger or thumb and release it so the door opens.

Ajouter un commentaire

Push the orange tab back and the battery will pop out.
  • Push the orange tab back and the battery will pop out.

Ajouter un commentaire

  • Remove four 2mm Phillips #000 screws.

  • Remove two black 3mm Phillips #000 screws.

  • Remove one 4mm Phillips #000 screws.

  • Remove two silver 3mm Phillips #000 screws.

Ajouter un commentaire

  • Use your fingers, or a spudger, to lift up one end of the casing and then pry the two pieces apart.

Ajouter un commentaire

  • Turn the camera over.

  • Use your fingers, or spudger, to lift one end of the back casing and pry it apart from back of the camera.

Ajouter un commentaire

  • Remove the single 3mm Phillips #000 screw from the back of the camera.

Ajouter un commentaire

  • Turn the camera over and pry the lens casing off by slipping your fingers, or spudger, under the lip of the casing.

  • Desolder the two wires connecting the casing to the motherboard.

  • Work carefully so that you do not break the soldered wires.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Matina Newsom

Membre depuis le 21/02/2018

747 Réputation

8 tutoriels rédigés

Équipe

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 4

Total : 36