Pièces

Aucune pièce nécessaire.

  1. Turn over camera to find 5 apparent screws.
    • Turn over camera to find 5 apparent screws.

    Ajouter un commentaire

  2. Remove all 5 screws from the bottom of the camera and store them carefully.
    • Remove all 5 screws from the bottom of the camera and store them carefully.

    Ajouter un commentaire

    • Open battery door by sliding it in the direction of the arrow to reveal a hidden screw on the opposite side of orange lever. Remove this screw.

    Ajouter un commentaire

  3. Livraison gratuite pour les commandes de plus de 20 $
    Indiquez le code BLUEANDBLACK au moment de payer
    Livraison gratuite pour les commandes de plus de 20 $
    Indiquez le code BLUEANDBLACK
    • Rotate camera to find side panel with lanyard attachment. Detach side panel by lifting bottom corner slightly with the spudger.

    Ajouter un commentaire

    • Lift the back cover, being careful not to rip the orange cables between the camera and the back cover.

    Ajouter un commentaire

    • With back cover lifted, lift the black flap that connects the ribbon to the motherboard with the spudger and carefully remove the back cover.

    Ajouter un commentaire

    • On back of LCD screen, locate the three screws underneath the ribbon and remove them.

    Ajouter un commentaire

    • Take out rectangular component on the side where the screws were.

    • Pry apart screen from back casing using the spudger.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Ryan

Membre depuis le 12/04/2011

131 Réputation

6 tutoriels rédigés

Équipe

Cal Poly, Team 18-24, Garner Spring 2011 Membre de l'équipe Cal Poly, Team 18-24, Garner Spring 2011

CPSU-GARNER-S11S18G24

4 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 4

Total : 2,121