Réparez vos affaires

Droit à la réparation

Boutique

Nikon Coolpix S70 Display Screen Replacement

Rédigé par : Danielle Morris (et 4 autres contributeurs)
  • Commentaires : 0
  • Favoris : 0
  • Réparations terminées : 3

Difficulté

Modérée

Étapes

6

Temps nécessaire

5 - 10 minutes

Sections

1

Drapeaux

1

Featured Student Guide

Tutoriel étudiant vedette

Ce tutoriel est le résultat du travail hors pair d'un de nos étudiants et notre équipe iFixit le trouve particulièrement réussi.

Introduction

This guide will assist you in replacing your broken, cracked or malfunctioning display screen. For this replacement you will need a Phillips #000 screwdriver and a plastic opening tool.

  1. Power off the camera before beginning. Remove the battery by sliding the latch located at the bottom of the camera.

    • Power off the camera before beginning.

    • Remove the battery by sliding the latch located at the bottom of the camera.

    Modifier

  2. Using a Phillips head #000 screwdriver, remove the five 0.4mm screws on the bottom of the camera. Using a Phillips head #000 screwdriver, remove the five 0.4mm screws on the bottom of the camera.

    • Using a Phillips head #000 screwdriver, remove the five 0.4mm screws on the bottom of the camera.

    Modifier

  3. Le kit d'outils Essentiel

    Les outils les plus utiles dans notre kit le plus compact.

    J'achète

    Le kit d'outils Essentiel

    Les outils les plus utiles dans notre kit le plus compact.

    J'achète

  4. Use a plastic opening tool to carefully separate the back panel of the camera. Once loosened, use your fingers to manually separate the two panels. Once loosened, use your fingers to manually separate the two panels.

    • Use a plastic opening tool to carefully separate the back panel of the camera.

    • Once loosened, use your fingers to manually separate the two panels.

    Modifier

  5. Using a plastic opening tool, lift both latches that hold the ribbon cables in place. Using a plastic opening tool, lift both latches that hold the ribbon cables in place. Using a plastic opening tool, lift both latches that hold the ribbon cables in place.

    • Using a plastic opening tool, lift both latches that hold the ribbon cables in place.

    Modifier

  6. Carefully disconnect the orange flat ribbon cables from the latches.

    • Carefully disconnect the orange flat ribbon cables from the latches.

    Modifier

  7. Remove the screen from the case of the camera by carefully pushing on the back of the screen. You may need to push with a little force to get the screen to loosen. You may need to push with a little force to get the screen to loosen.

    • Remove the screen from the case of the camera by carefully pushing on the back of the screen.

    • You may need to push with a little force to get the screen to loosen.

    Modifier
Conclusion

To reassemble your device, follow these instructions in reverse order.

3 autre(s) ont terminé cette réparation.

Auteur

avec 4 autres contributeurs

Danielle Morris

Membre depuis le 24/09/2015

165 Réputation

1 tutoriel rédigé

Badges: 10

+ 7 badges supplémentaires

Équipe

Texas Tech, Team 22-2, Rauch Fall 2015 Membre de l'équipe Texas Tech, Team 22-2, Rauch Fall 2015

TTU-RAUCH-F15S22G2

3 membres

1 tutoriel rédigé

0 commentaires

Ajouter un commentaire

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 3

Total : 748