Nikon D40 Back Cover Replacement

Ce tutoriel a des changements plus récents. Passer à la dernière version non vérifiée.

Introduction

This guide will demonstrate the proper procedure to remove the back panel without damaging the internals of the camera so that you can access a variety of the components hidden behind it.

Ce dont vous avez besoin

Étape 1 Back Cover

Nikon D40 Back Cover Replacement, Back Cover: étape 1, image 1 de 1

Remove the two visible 6.0 mm Philips #0 screws on the left and right sides of the viewfinder. These screws are highlighted in red.

Traduire

Étape 2

Remove the four 6.0 mm Philips #0 screws on the left and right sides of the camera.

Traduire

Étape 3

Remove the four highlighted 3.0 mm Philips #0 screws on the bottom of the camera.

Traduire

Étape 4

While pulling the bottom down, remove the back of the camera.
Be careful not to pull too hard on the back as it is connected via a ribbon cable. Be sure to disconnect this cable on the main board.
To disconnect the ribbon cable pull the small black tab upward and pull gently on the cable.