Pièces

Aucune pièce nécessaire.

Remove the five screws on the bottom of the camera with a JIS #000 head screwdriver.
  • Remove the five screws on the bottom of the camera with a JIS #000 head screwdriver.

Ajouter un commentaire

Remove the 3 screws under the battery flap and remove the bottom cover.
  • Remove the 3 screws under the battery flap and remove the bottom cover.

Ajouter un commentaire

  • Remove the 2 screws inside the camera on the back corners.

Ajouter un commentaire

  • Open the HDMI flap and remove the 2 screws.

Ajouter un commentaire

  • Remove the screw next to the camera strap loop.

Ajouter un commentaire

  • Remove the 2 screws on each side of the view finder.

Ajouter un commentaire

  • Remove the 2 screws above and below the SD card flap.

Ajouter un commentaire

  • Peel off the adhesive leather screw cover and remove the 2 screws under it.

Ajouter un commentaire

  • Remove the Diopter adjustment control sticker and remove the screw under it.

Ajouter un commentaire

  • Separate the back panel of the camera from the actual camera.

  • Be careful not to tear any of the ribbon cables.

Ajouter un commentaire

  • Disconnect the LCD ribbon cables and power cable from the motherboard.

Ajouter un commentaire

  • Unscrew all 16 screws around the back plate of the camera.

Ajouter un commentaire

  • Then unscrew the remaining screws holding the back plate to the LCD.

  • Then simply remove the plate with the LCD.

Ajouter un commentaire

  • Undo the 5 ribbon cable connectors by flipping the latches up with a plastic spudger.

Ajouter un commentaire

  • Remove the black 4 pin connector by pulling it out of the connector.

Ajouter un commentaire

  • Remove the 7 screws holding the motherboard in place.

Ajouter un commentaire

  • This is what you should see after removing the motherboard.

Ajouter un commentaire

Conclusion

Remember to replace your broken components. Then follow the instructions in reverse order to reassemble your device.

2 autre(s) ont terminé cette réparation.

Alexander DiMartino

Membre depuis le 06/03/2018

124 Réputation

1 tutoriel rédigé

Équipe

USF Tampa, Team S11-G6, Cheng Spring 2018 Membre de l'équipe USF Tampa, Team S11-G6, Cheng Spring 2018

USFT-CHENG-S18S11G6

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 12

30 derniers jours : 67

Total : 261