Réparez vos affaires Communauté Boutique

Nintendo 3DS Lower Case Replacement

Introduction

Remove your broken Nintendo 3DS lower case and replace it with a fresh one.

Ce dont vous avez besoin

  1. Nintendo 3DS Lower Case Replacement, Back Cover: étape 1, image 1 de 1

    • Unscrew the four Phillips #00 screws along the top of the back cover.

    • The screws are held in place by locking washers, and will not come out of the back cover.

    • The comments section is full of unlucky souls who will tell you that the screws here through step 4 will strip incredibly easily. Press down fairly hard, and go slow.

    Traduire

  2. Nintendo 3DS Lower Case Replacement: étape 2, image 1 de 2 Nintendo 3DS Lower Case Replacement: étape 2, image 2 de 2

    • Hold the device in one hand and turn it over.

    • Grab the top edge of the back cover with your opposite hand so that the cover does not fall back into place.

    • Flip the 3DS over again so that the back cover is facing up.

    • Pull the back cover up and away from the rest of the device to remove it.

    Traduire

  4. Nintendo 3DS Lower Case Replacement, Battery: étape 3, image 1 de 3 Nintendo 3DS Lower Case Replacement, Battery: étape 3, image 2 de 3 Nintendo 3DS Lower Case Replacement, Battery: étape 3, image 3 de 3

    • Insert a plastic opening tool into the notch in the lower case above the battery.

    • Pry the battery up with the plastic opening tool.

    • Grab the top edge of the battery and lift it out of the lower case.

    Traduire

  5. Nintendo 3DS Lower Case Replacement, Lower Case: étape 4, image 1 de 1

    • Remove the nine 6.3 mm black Phillips screws from the lower case.

    • Remove the 2.4 mm silver Phillips screw above the game cartridge slot.

    Traduire

  6. Nintendo 3DS Lower Case Replacement: étape 5, image 1 de 3 Nintendo 3DS Lower Case Replacement: étape 5, image 2 de 3 Nintendo 3DS Lower Case Replacement: étape 5, image 3 de 3

    • Lift the bottom edge of the lower case off the rest of the 3DS.

    • There are still two ribbon cables connecting the mother board to the case, so be sure not to pull the lower case all the way off.

    • Use a plastic opening tool to pry the shoulder button ribbon cables off their sockets on the motherboard.

    • Remove the lower case from the device.

    Traduire
Conclusion

To reassemble your device, follow these instructions in reverse order.

7 autres ont terminé cette réparation.

Auteur

avec 5 autres contributeurs

David Hodson

Membre depuis le 04/13/10

150 467 Réputation

127 tutoriels rédigés

Badges: 53

+ 50 badges supplémentaires

2 commentaires

Is this guide for the original 3ds?

Glenn Racz - Réponse

yessir it is

Electronik -

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 4

7 derniers jours : 25

30 derniers jours : 110

Total : 15,668