Introduction

Be the envy of onlooking gamers with a shiny new rear bezel on your DSi XL.

Use a push pin to remove the four plastic screw covers on the front bezel.
  • Use a push pin to remove the four plastic screw covers on the front bezel.

Ajouter un commentaire

Remove four Phillips screws securing the front bezel to the rear bezel.
  • Remove four Phillips screws securing the front bezel to the rear bezel.

Ajouter un commentaire

  • Using two hands, gently slide the rear bezel upwards.

  • The rear bezel will move only about 2 mm.

Ajouter un commentaire

  • Insert a spudger into the gap between the front and rear bezel

  • Rotate the spudger away from the DSi XL, prying the two bezels apart.

Ajouter un commentaire

  • In the same manner as described above, continue prying along the top edge of the front and rear bezels.

Ajouter un commentaire

  • Separate the rear bezel from the front bezel.

  • Do not attempt to completely remove the rear bezel yet. It is still attached to the front bezel by the rear-facing camera.

Ajouter un commentaire

  • Use the flat end of a spudger to pry the rear camera off the rear bezel.

  • Remove the rear bezel.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Matthew Newsom

Membre depuis le 05/01/2010

31 755 Réputation

67 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 4,227