Introduction

Give your DSi a memory boost by repairing your SD board.

  1. Remove the two Phillips screws securing the battery cover to the back of the handheld console.
    • Remove the two Phillips screws securing the battery cover to the back of the handheld console.

    • Lift the battery cover off the back of the DSi XL.

    Ajouter un commentaire

  2. Lift the battery from the DSi XL.
    • Lift the battery from the DSi XL.

    Ajouter un commentaire

    • Remove the four rubber screw covers on the lower case by prying them up with a push pin.

    Ajouter un commentaire

    • Remove the following seven Phillips screws that secure the lower case to the rest of the DSi XL:

      • Four silver 5.3 mm screws

      • Two black 5.3 mm screws

      • One black 2.5 mm screw

    Ajouter un commentaire

    • Turn the DSi XL over, and open the display.

    • Insert a spudger between the upper and lower case at the bottom left corner of the DSi.

    • Slide the spudger along the bottom edge of the upper case to release the latches securing the upper case to the lower case.

    Ajouter un commentaire

    • Close the display and turn the DSi XL over.

    • Lift the lower case from the front edge.

    • Rotate the lower case away from the DSi.

    • The lower case cannot be completely removed yet, since it is still connected to the motherboard.

    Ajouter un commentaire

    • Using a spudger, pry the SD card/right shoulder button connector off its socket.

    • Pry the volume button/left shoulder button connector off its socket on the motherboard with a spudger.

    Ajouter un commentaire

    • Remove the two gold 4.0 mm Phillips screws securing the right shoulder button assembly to the back case.

    • Lift the right shoulder button assembly from the back case.

    • The components of the right shoulder button assembly:

      • Right shoulder button

      • Shoulder button spring

      • Retaining pin

      • Right shoulder button holding panel

    Ajouter un commentaire

    • Remove the stylus from its housing on the right side of the DSi XL.

    Ajouter un commentaire

    • Remove the three 4 mm gold Phillips screws securing the stylus housing to the lower case.

    • Using a spudger, lift the stylus housing off the lower case.

    • Remove the stylus housing from the handheld console.

    Ajouter un commentaire

    • Lift the SD board off the lower case.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Brett Hartt

Membre depuis le 12/04/2010

108 299 Réputation

138 tutoriels rédigés

Équipe

iFixit Membre de l'équipe iFixit

Community

114 membres

6 996 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 3

Total : 5,433