Introduction

In this step we will be removing the bottom panel from the rest of the controller. This is necessary in order to access the inside components of the controller.

WARNING: Use caution when removing the bottom grip panel. Many of the buttons and components are held only loosely by the front panel and can fall out. Be sure to set screws aside carefully.

Pièces

Aucune pièce nécessaire.

Place the controller (buttons down) on a solid surface.
  • Place the controller (buttons down) on a solid surface.

  • Remove the six 9.2mm Tri-wing Y0 screws that hold the back panel in place.

Ajouter un commentaire

Gently lift the back panel up, separating it from the front panel.
  • Gently lift the back panel up, separating it from the front panel.

  • Some of the buttons may fall out if they are knocked around.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

5 autre(s) ont terminé cette réparation.

Jeffrey Hufford

Membre depuis le 18/01/2013

77 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 19-44, Regan Winter 2013 Membre de l'équipe Cal Poly, Team 19-44, Regan Winter 2013

CPSU-REGAN-W13S19G44

4 membres

16 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 5

7 derniers jours : 15

30 derniers jours : 66

Total : 5,872