Réparez vos affaires Communauté Boutique

Nintendo GameCube Controller Directional Pad Replacement

Introduction

This guide will demonstrate proper removal of the D-Pad. This is necessary in order to clean or replace it.

Ce dont vous avez besoin

  1. Nintendo GameCube Controller Directional Pad Replacement, Back Panel: étape 1, image 1 de 1

    • Place the controller (buttons down) on a solid surface.

    • Remove the six 9.2mm Tri-wing Y0 screws that hold the back panel in place.

    Modifier

  2. Nintendo GameCube Controller Directional Pad Replacement: étape 2, image 1 de 1

    • Gently lift the back panel up, separating it from the front panel.

    • Some of the buttons may fall out if they are knocked around.

    Modifier

  3. Nintendo GameCube Controller Directional Pad Replacement, Z Button: étape 3, image 1 de 2 Nintendo GameCube Controller Directional Pad Replacement, Z Button: étape 3, image 2 de 2

    • Grab the Z-button by the peg with tweezers and lift it out of the controller.

    • During re-assembly, make sure the plastic rim and spring fit into the slot provided, or else the case will not shut.

    Modifier

  5. Nintendo GameCube Controller Directional Pad Replacement, Circuit Board: étape 4, image 1 de 1

    • Carefully unhook the cable that is looped around the peg.

    Modifier

  6. Nintendo GameCube Controller Directional Pad Replacement: étape 5, image 1 de 1

    • Lift the circuit board out of the controller.

    • Do not grab the rumble motor to lift the circuit board as shown in the picture. It will in many cases just remove the rumble motor. Instead, grab the edges of the board.

    Modifier

  7. Nintendo GameCube Controller Directional Pad Replacement, Directional Pad: étape 6, image 1 de 1

    • Remove the rubber backing with tweezers.

    Modifier

  8. Nintendo GameCube Controller Directional Pad Replacement: étape 7, image 1 de 1

    • Use tweezers to grab the center peg of the directional pad and lift it out of its socket.

    Modifier
Conclusion

To reassemble your device, follow these instructions in reverse order.

5 autres ont terminé cette réparation.

Auteur

avec 4 autres contributeurs

Sean Michel

Membre depuis le 01/14/13

2 496 Réputation

8 tutoriels rédigés

Badges: 17

+ 14 badges supplémentaires

Équipe

Cal Poly, Team 19-44, Regan Winter 2013 Membre de l'équipe Cal Poly, Team 19-44, Regan Winter 2013

CPSU-REGAN-W13S19G44

4 membres

26 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 2

7 derniers jours : 8

30 derniers jours : 36

Total : 6,582