Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Boutique

Introduction

This guide will help you remove the front panel of the controller. It is a prerequisite guide only.

Pièces

Aucune pièce spécifiée.

  1. Pull down on the battery cover release lever and pull back to remove the cover. Pull down on the battery cover release lever and pull back to remove the cover.
    • Pull down on the battery cover release lever and pull back to remove the cover.

  2. Remove both batteries from the device.
    • Remove both batteries from the device.

  3. Remove the eight 9 mm screws from the back panel using the Tri-point Y1 screwdriver. During reassembly, firmly hold the panels of the controller together while replacing the screws so the panels do not separate.
    • Remove the eight 9 mm screws from the back panel using the Tri-point Y1 screwdriver.

    • During reassembly, firmly hold the panels of the controller together while replacing the screws so the panels do not separate.

  4. Carefully turn over the controller and place it on a flat surface. Slowly separate the top panel from the bottom panel.
    • Carefully turn over the controller and place it on a flat surface.

    • Slowly separate the top panel from the bottom panel.

    • The buttons are loose and may fall off the motherboard.

    • Once separated, set aside the top panel.

    • During reassembly, make sure the front panel lines up with the buttons so they slide back into place.

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

JT Gryder

Membre depuis le 12/04/2013

78 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 10-40, Amido Spring 2013 Membre de l'équipe Cal Poly, Team 10-40, Amido Spring 2013

CPSU-AMIDO-S13S10G40

4 membres

23 tutoriels rédigés

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 21

Total : 1,080