Aller au contenu principal

Introduction

If you have cracked or damaged your screen, this guide will provide you with a step by step instructions on how to take the device apart to access it.

  1. Using the thumbtab molded on the bottom of the phone, pry the back cover off using either a fingernail or a plastic opening tool. Using the thumbtab molded on the bottom of the phone, pry the back cover off using either a fingernail or a plastic opening tool.
    • Using the thumbtab molded on the bottom of the phone, pry the back cover off using either a fingernail or a plastic opening tool.

  2. There is a molded notch in the white frame of the phone near the top right of the battery.  Using either a finger or a plastic opening tool, utilize the notch to lift up on the battery, and remove it from the device. This specific device did not come with a battery.
    • There is a molded notch in the white frame of the phone near the top right of the battery. Using either a finger or a plastic opening tool, utilize the notch to lift up on the battery, and remove it from the device.

    • This specific device did not come with a battery.

  3. Using a T5 screwdriver bit, remove the (6) 5.0 mm screws along the outside edge of the frame. Using a metal spudger, wedge the 6 plastic tabs molded into the outer shell away from the frame to lift up and remove it. Using a metal spudger, wedge the 6 plastic tabs molded into the outer shell away from the frame to lift up and remove it.
    • Using a T5 screwdriver bit, remove the (6) 5.0 mm screws along the outside edge of the frame.

    • Using a metal spudger, wedge the 6 plastic tabs molded into the outer shell away from the frame to lift up and remove it.

  4. Use a spudger to simultaneously leverage the shell away and the motherboard up from the body of the shell. Use a spudger to simultaneously leverage the shell away and the motherboard up from the body of the shell. Use a spudger to simultaneously leverage the shell away and the motherboard up from the body of the shell.
    • Use a spudger to simultaneously leverage the shell away and the motherboard up from the body of the shell.

  5. With the motherboard removed, the only thing holding the screen into place is the snap plug on the back of the motherboard. Using a spudger, leverage the top snap up to disconnect it (photo shows motherboard rotated 90 degrees counterclockwise). Using a spudger, leverage the top snap up to disconnect it (photo shows motherboard rotated 90 degrees counterclockwise).
    • With the motherboard removed, the only thing holding the screen into place is the snap plug on the back of the motherboard.

    • Using a spudger, leverage the top snap up to disconnect it (photo shows motherboard rotated 90 degrees counterclockwise).

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 autres ont terminé cette réparation.

Aaron LeBlanc

Membre depuis le 24/10/2018

648 Réputation

5 tutoriels rédigés

Équipe

UMass Dartmouth, Team S3-G3, Peak Fall 2018 Membre de l'équipe UMass Dartmouth, Team S3-G3, Peak Fall 2018

UMASSD-PEAK-F18S3G3

3 membres

8 tutoriels rédigés

2 commentaires

If you can break the screen without taking it apart, then you must not be human

Feyrowan - Réponse

The Cylons are greeting you.

M. H. -

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 18

Total : 914