Ce tutoriel a des changements plus récents. Passer à la dernière version non vérifiée.
Introduction
Below is a list of instructions on replacing and cleaning a Nokia 6133 keypad.
Ce dont vous avez besoin
-
-
Remove the back cover of your cell phone by applying slight pressure with your thumb and pushing up towards the top of the phone.
-
Lift off back cover.
-
-
-
-
Unscrew two T5 torx screws easily visible on the back side of the cell phone
-
Screws: 7.8mm
-
Once screw are removed, the phone will separate easily into two pieces connected by a flexible wire strip.
-
-
-
Use an iPod opening tool to gently pry open the back case as indicated in the picture.
-
Work your way down the side of the phone starting from the top down to the bottom. (Use multiple prying tools if necessary)
-
REPEAT on both sides, and be careful not to stab the circuitry with the tools.
-
-
-
Gently pull the phone apart and the flexible wire should detach from its connection as shown.
-
If not, lift up on the black tab within the left box in the picture.
-
With the front half of the phone, push the keypad towards the removed portion of the phone.
-
To clean, use a damp cloth with water.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
Une autre personne a terminé cette réparation.
Équipe
Cal Poly, Team 23-82, Johann Spring 2010 Membre de l'équipe Cal Poly, Team 23-82, Johann Spring 2010
CPSU-JOHANN-S10S23G82
4 membres
5 tutoriels rédigés
