Introduction

This guide requires that the front plate, keypad, circuit board, back cover, and battery all be removed.

Pièces

Aucune pièce nécessaire.

Pull up on both of the clips near the bottom of the phone as shown.
  • Pull up on both of the clips near the bottom of the phone as shown.

  • Lift off the front plate.

Ajouter un commentaire

The keypad and LCD screen are revealed.
  • The keypad and LCD screen are revealed.

Ajouter un commentaire

  • Separate the keypad from the phone and place aside.

  • Wipe off any excess dust from where the keypad was attached to the phone.

Ajouter un commentaire

  • Remove the six screws highlighted by the markers using the screwdriver.

Ajouter un commentaire

  • Separate the inside of the phone from the back of the phone.

Ajouter un commentaire

  • Locate vibration device on the bottom of the back cover.

  • Pull up on the vibration device using tweezers.

  • Remove the vibration device and place it aside.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Reid Polstra

Membre depuis le 22/10/2012

1 Réputation

7 tutoriels rédigés

Équipe

Clemson, Team 15-5, Benson Fall 2012 Membre de l'équipe Clemson, Team 15-5, Benson Fall 2012

CLEM-BENSON-F12S15G5

3 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 434