Réparez vos affaires Communauté Boutique

Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement

Introduction

This repair is very easy; all you need is a T5 Torx Screwdriver, and a new Digitizer Glass & Frame Assebly - it's better to order it with the Front Frame as well, as it makes repairing a lot simpler, and will give your phone a new look and feel.

Ce dont vous avez besoin

  1. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement, Touchscreen Glass / Digitizer Assembly: étape 1, image 1 de 1

    • The first thing you'll need is a Nokia Lumia 610 with a broken front glass

    Modifier

  2. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: étape 2, image 1 de 2 Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: étape 2, image 2 de 2

    • Slide the back cover off, and remove the battery

    Modifier

  3. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: étape 3, image 1 de 2 Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: étape 3, image 2 de 2

    • There are 8 Torx 5 screws you have to remove, 4 on each side

    Modifier

  4. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: étape 4, image 1 de 3 Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: étape 4, image 2 de 3 Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: étape 4, image 3 de 3

    • After removing all 8 screws, proceed to prying off the back cover

    • This is done very easily, by prying it from the 3 grooves depicted

    • This step might also be done using your nails, as the clips are not strong at all

    Modifier

  5. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: étape 5, image 1 de 1

    • Watch out - the buttons easily fall out; just make sure you don't loose any, a'aight ?!

    Modifier

  7. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: étape 6, image 1 de 2 Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: étape 6, image 2 de 2

    • Lift the back cover up, and pull it back - most likely, the 2 sided tape sealing the camera module will be the last thing to break loose

    • Make sure you stick it back to the rear case assembly after this step

    Modifier

  8. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: étape 7, image 1 de 3 Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: étape 7, image 2 de 3 Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: étape 7, image 3 de 3

    • Disconnect the 2 ribbon cables connecting the LCD & Digitizer to the motherboard

    Modifier

  9. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: étape 8, image 1 de 1

    • Now to separate the Motherboard from the front assembly !

    • Gently pry on the 2 hooks depicted in the picture to release the motherboard

    • Again - using your nails should be just fine !

    Modifier

  10. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: étape 9, image 1 de 2 Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: étape 9, image 2 de 2

    • Lift the motherboard up from the back, and pull it backwards

    • Apply the same motion as with the back casing

    • You should now have separated the motherboard from the LCD/Digitizer Assembly

    Modifier

  11. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: étape 10, image 1 de 2 Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: étape 10, image 2 de 2

    • To detach the LCD, gently lift it from the sides - be careful, and don't pull too hard on the ribbon cable !

    • It's secured in with pretty weak double-sided tape, so this step shouldn't be a problem

    Modifier

  12. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: étape 11, image 1 de 2 Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: étape 11, image 2 de 2

    • Remove the ear-piece speaker from the Digitizer Assembly

    • It's held in by - again - pretty weak double-sided tape

    • 2nd picture gives you a look of the front of the speaker unit - it's pretty hard to damage the membrane - though, you can never be too careful !

    Modifier

  13. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: étape 12, image 1 de 2 Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: étape 12, image 2 de 2

    • Something very easy to forget - remove the tiny rubber gasket for the microphone, and place it in the new front panel

    Modifier

  14. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: étape 13, image 1 de 1

    • To put everything back together, just follow the same steps backward, and you should have yourself a good-as-new Nokia Lumia 610

    • The last step in this guide - is trying not to break it again :)

    Modifier
Conclusion

To reassemble your device, follow these instructions in reverse order.

6 autres ont terminé cette réparation.

Auteur

avec 2 autres contributeurs

Darie H

Membre depuis le 11/20/12

4 550 Réputation

5 tutoriels rédigés

Badges: 16

+ 13 badges supplémentaires

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 1

7 derniers jours : 3

30 derniers jours : 3

Total : 5,708