Introduction

This guide will show you how to remove the back cover revealing the battery. This will allow you to access the inside of the nook tablet and will act as prerequisite for most of the other guides

Pièces

Aucune pièce nécessaire.

  1. Flip the Nook over.
    • Flip the Nook over.

    Ajouter un commentaire

  2. Lift the flap that reads "Nook" to reveal the tape that is underneath. Remove the memory card if one is present.
    • Lift the flap that reads "Nook" to reveal the tape that is underneath. Remove the memory card if one is present.

    • Remove the tape covering the round holes to reveal two T5 Torx screws.

    • Remove the two T5 Torx screws securing the back cover.

    Remove stickers covering T5 screws and remove screws

    badbyz - Réponse

    Also, remove the mini SD card first or you may break it taking the back off.

    54pontiac - Réponse

    • Insert the flat end of a spudger between the front panel and the rear assembly.

      • Though these photos show a screwdriver, use a spudger or plastic opening tool in order to prevent damage to the device.

    • Use a spudger to lift the the back panel from the rest of the Nook.

    Ajouter un commentaire

    • Slide the spudger around the edges of the Nook to loosen the back panel.

    Ajouter un commentaire

    • Pull the back panel off the Nook.

    Ajouter un commentaire

Conclusion

To reassemble your device, line up the piece that was removed with how it was on before and then just firmly press down till it snaps into place.

4 autre(s) ont terminé cette réparation.

Jacob Metzinger

Membre depuis le 25/09/2012

80 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 1-4, Propen Fall 2012 Membre de l'équipe Cal Poly, Team 1-4, Propen Fall 2012

CPSU-PROPEN-F12S1G4

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 6

Total : 5,061