Introduction

If some buttons are not working on your phone, use this guide to replace them.

Pièces

Aucune pièce nécessaire.

Flip the phone over to view the back.
  • Flip the phone over to view the back.

  • Remove the power and phone cords.

Ajouter un commentaire

Remove the seven 8mm Phillips #2 screws.
  • Remove the seven 8mm Phillips #2 screws.

Ajouter un commentaire

  • Lift up the back cover slowly because there are still wires attached to the circuit board.

  • Lifting the back cover should not require a lot of force; simply lift with your fingertips.

Ajouter un commentaire

  • Disconnect the rubber piece by pulling it out of the slot, freeing the back cover completely.

Ajouter un commentaire

  • Remove the six 8mm Phillips #2 screws.

  • Pull the speaker phone cover straight up.

Ajouter un commentaire

  • Remove the red and white wires from the rubber casing rim.

Ajouter un commentaire

  • Lift out the speaker and set it away from the tray that holds it.

  • Then remove the black plastic tray at the bottom by lifting it straight up.

Ajouter un commentaire

  • Remove the two 8mm Phillips #2 screws.

Ajouter un commentaire

  • Pull the gray plastic casing away from the circuit board as you remove the clear, curved, plastic piece straight up.

Ajouter un commentaire

  • There are three clips on the circuit board to un-clip.

  • Unclip both back black clips with your fingertips.

  • Push the middle black clip towards the bottom of the picture with a flathead screwdriver.

Ajouter un commentaire

  • There's a brown ribbon still attached to the circuit board and phone case, so don't pull the circuit board completely off just yet.

  • Lift the edge of the circuit board over the phone case and slightly up, so the bottom of circuit board can be viewed.

Ajouter un commentaire

  • Push down each brown clip on either side of the brown metal strip using your fingertip.

  • Detach the circuit board from the brown ribbon.

Ajouter un commentaire

  • Remove the clear rubber casing.

  • Be careful not to flip over the front phone casing or all of the buttons will fall out.

Ajouter un commentaire

  • Press the broken button from the front of the phone.

  • Remove the broken button through the back.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Andrew Wang

Membre depuis le 19/01/2012

9 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 10-35, Amido Winter 2012 Membre de l'équipe Cal Poly, Team 10-35, Amido Winter 2012

CPSU-AMIDO-W12S10G35

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 2

Total : 908