Introduction

This guide will help you remove the circuit board from the outer telephone case. You may need to remove the circuit board to repair internal components, such as buttons.

Pièces

Aucune pièce nécessaire.

Flip the phone over to view the back.
  • Flip the phone over to view the back.

  • Remove the power and phone cords.

Ajouter un commentaire

Remove the seven 8mm Phillips #2 screws.
  • Remove the seven 8mm Phillips #2 screws.

Ajouter un commentaire

  • Lift up the back cover slowly because there are still wires attached to the circuit board.

  • Lifting the back cover should not require a lot of force; simply lift with your fingertips.

Ajouter un commentaire

  • Disconnect the rubber piece by pulling it out of the slot, freeing the back cover completely.

Ajouter un commentaire

  • Remove the six 8mm Phillips #2 screws.

  • Pull the speaker phone cover straight up.

Ajouter un commentaire

  • Remove the red and white wires from the rubber casing rim.

Ajouter un commentaire

  • Lift out the speaker and set it away from the tray that holds it.

  • Then remove the black plastic tray at the bottom by lifting it straight up.

Ajouter un commentaire

  • Remove the two 8mm Phillips #2 screws.

Ajouter un commentaire

  • Pull the gray plastic casing away from the circuit board as you remove the clear, curved, plastic piece straight up.

Ajouter un commentaire

  • There are three clips on the circuit board to un-clip.

  • Unclip both back black clips with your fingertips.

  • Push the middle black clip towards the bottom of the picture with a flathead screwdriver.

Ajouter un commentaire

  • There's a brown ribbon still attached to the circuit board and phone case, so don't pull the circuit board completely off just yet.

  • Lift the edge of the circuit board over the phone case and slightly up, so the bottom of circuit board can be viewed.

Ajouter un commentaire

  • Push down each brown clip on either side of the brown metal strip using your fingertip.

  • Detach the circuit board from the brown ribbon.

Ajouter un commentaire

  • Remove the clear rubber casing.

  • Be careful not to flip over the front phone casing or all of the buttons will fall out.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Elizabeth

Membre depuis le 21/01/2012

160 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 10-35, Amido Winter 2012 Membre de l'équipe Cal Poly, Team 10-35, Amido Winter 2012

CPSU-AMIDO-W12S10G35

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 15

Total : 1,672