Menu 

Vos paramètres

Nostalgia Electrics RHP-310 Power Switch Replacement

Rédigé par : Dana Clarke (et 6 autres contributeurs)
  • Commentaires : 0
  • Favoris : 1

Difficulté

Modérée

Étapes

6

Temps nécessaire

5 - 10 minutes

Sections

1

Drapeaux

1

Bullets!

Puces !

Une bonne utilisation des balises, de la couleur et/ou du format des puces donnera de la clarté à ce tutoriel !

Introduction

If the device will not turn on or has a broken power switch, use this guide to replace the switch.

Outils

Acheter ces outils

Pièces

Aucune pièce spécifiée.

  1. Unplug popper.

    • Unplug popper.

    • Remove plastic lid by picking the lid up.

    Traduire

  2. Flip the popper on its side.

    • Flip the popper on its side.

    • Remove the screws on the bottom with the Phillips #2 phillips head screwdriver.

    • There are seven screws on the base. Five screws on the perimeter (12mm Philips #2 screws) and two in the middle (15 mm Philips #2 screws).

    Traduire

  4. Remove the base.

    • Remove the base.

    • Save the screws you took out of the bottom in a safe place. They will be needed to reattach the housing to the base.

    • Unscrew the two screws (10 mm Philips #2 screws) from the base.

    • Remove the base and set it aside for now.

    Traduire

  5. Locate the power switch connected to the side of the housing. Carefully pinch the sides of the power switch.

    • Locate the power switch connected to the side of the housing.

    • Carefully pinch the sides of the power switch.

    • Push the power button up and out of the housing.

    Traduire

  6. Now that the power switch is removed from the housing, you have to remove the wires connected to the power switch.

    • Now that the power switch is removed from the housing, you have to remove the wires connected to the power switch.

    • Use the plastic opening tool to gently pry the wires loose from the power switch.

    • The wires should pop easily out from the power switch.

    Traduire

  7. Remove the power switch from the device.

    • Remove the power switch from the device.

    • You can now replace the power switch if necessary.

    Traduire
Conclusion

To reassemble your device, follow these instructions in reverse order.

Auteur

avec 6 autres contributeurs

Dana Clarke

Membre depuis le 26/09/2012

26 Réputation

6 tutoriels rédigés

Badges: 4

+ 1 badge de plus

Équipe

Cal Poly, Team 16-57, Forte Fall 2012 Membre de l'équipe Cal Poly, Team 16-57, Forte Fall 2012

CPSU-FORTE-F12S16G57

5 membres

6 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 772