Introduction

Make sure device is unplugged.

  1. Remove slip mat from top of the platter.
    • Remove slip mat from top of the platter.

    Ajouter un commentaire

  2. Remove platter by inserting thumbs in holes and slowly pulling up.
    • Remove platter by inserting thumbs in holes and slowly pulling up.

    • There will be some initial resistance.

    Ajouter un commentaire

    • Remove damaged belt which will be located below the platter.

    Ajouter un commentaire

    • Install new belt by securing it around the inner ring, located on the back of the platter.

    Ajouter un commentaire

    • Place a thumb in each hole.

    • You should be able to feel the rubber belt.

    • Gently pull the belt with each thumb, keeping the belt taut around the inner ring.

    Ajouter un commentaire

    • Secure platter back on turntable while keeping belt taut.

    • Pull belt around motor spindle.

    • Gently let go of belt.

    Ajouter un commentaire

    • Test turntable by spinning the platter.

    • There should be slight tension causing the platter to come to a stop.

    Ajouter un commentaire

Ligne d'arrivée

Une autre personne a terminé cette réparation.

Nikolai

Membre depuis le 12/10/2011

161 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team 17-14, Regan Fall 2011 Membre de l'équipe Cal Poly, Team 17-14, Regan Fall 2011

CPSU-REGAN-F11S17G14

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 14

30 derniers jours : 40

Total : 3,299