Introduction
Disassembling the remote requires removing screws under the batteries.Removing anything inside will require caution and time .
Ce dont vous avez besoin
-
-
-
First flip controller so that the back plate faces you
-
Remove the battery cover by pushing up on the bottom plate
Demander à FixBot
-
-
-
Remove both batteries if their are any inside the remote .
-
To remove them press down on the positive end then pull to take out
-
-
-
-
Using the tri-point Y1 Screw driver remove the two center screws by turning counter clock wise
-
Repeat process for bottom two
-
-
-
To fully take off the back piece you will have to use your flat head screw driver and gently go along the edge and unclip it.
-
Gently pull out the whole circuit board ( be careful you may break or rip a wire if you pull to hard )
-
-
-
To remove the buttons you will simply have to take off the grey silicon cover.
-
To remove the small speaker you can simply pull up .
-
-
-
Gently pry the buttons upwards ,removing the buttons from its holding slot.
-
CAUTION : WATCH OUT FOR SMALL BUTTONS !
-
-
