Introduction

Removal of the front plate to get into the logic board, lens, etc.

Pièces

Aucune pièce nécessaire.

  1. Flip camera so you are looking at the bottom.
    • Flip camera so you are looking at the bottom.

    • Unscrew all 5 base plate screws.

  2. Lift open retainer clip by sliding the clip to the left and letting the clip pop up.
    • Lift open retainer clip by sliding the clip to the left and letting the clip pop up.

  3. Unscrew the single screw located next to the battery slot.
    • Unscrew the single screw located next to the battery slot.

  4. %Livraison gratuite pour toute commande supérieure à 100,00 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique

    Vous avez déjà réparé quelque chose ? Vous êtes un génie.

    Partagez votre réparation avec le hashtag #ImAGenius

    Nous sommes tous des génies

    Partagez votre réparation avec le hashtag #ImAGenius

  5. Turn the camera so that the USB, AV and DC in/out rubber plate it facing you.
    • Turn the camera so that the USB, AV and DC in/out rubber plate it facing you.

    • Lift the rubber plate exposing the ports beneath.

  6. Unscrew the 2 screws next to the USB and AC ports.
    • Unscrew the 2 screws next to the USB and AC ports.

  7. Use a flathead screwdriver or another flat opening tool to pry the faceplate from the whole device.
    • Use a flathead screwdriver or another flat opening tool to pry the faceplate from the whole device.

  8. Pull off the faceplate to reveal the inside of the camera.
    • Pull off the faceplate to reveal the inside of the camera.

    • Be careful of the connector that goes from the faceplate to the motherboard . Disconnecting this line will cause the camera not not power on through the on/off switch anymore.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Katie

Membre depuis le 15/04/2010

25 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 28-23, Regan Spring 2010 Membre de l'équipe Cal Poly, Team 28-23, Regan Spring 2010

CPSU-REGAN-S10S28G23

4 membres

7 tutoriels rédigés

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 1,500