Réparez vos affaires Communauté Boutique

Olympus D590 Retainer Clip Replacement

Introduction

This guide shows how to replace a broken retainer clip (the plastic piece that covers the battery and XD card slot).

Ce dont vous avez besoin

  1. Olympus D590 Retainer Clip Replacement, Face Plate: étape 1, image 1 de 1

    • Remove five baseplate screws using a Phillips #00 screwdriver.

    Modifier

  2. Olympus D590 Retainer Clip Replacement: étape 2, image 1 de 1

    • Press and slide the battery cover retainer clip to the left. Use tweezers to lift the battery cover away.

    Modifier

  3. Olympus D590 Retainer Clip Replacement: étape 3, image 1 de 1

    • Remove the single screw from the battery housing using a Phillips #00 screwdriver.

    Modifier

  4. Olympus D590 Retainer Clip Replacement: étape 4, image 1 de 1

    • Using tweezers, lift the rubber plate to expose the ports.

    Modifier

  6. Olympus D590 Retainer Clip Replacement: étape 5, image 1 de 1

    • Remove two screws from the ports using a Phillips #00 screwdriver.

    Modifier

  7. Olympus D590 Retainer Clip Replacement: étape 6, image 1 de 1

    • Use a spudger to pry the faceplate away from the rest of the camera.

    Modifier

  8. Olympus D590 Retainer Clip Replacement: étape 7, image 1 de 1

    • To avoid disconnection of the connector line to the motherboard, use caution when pulling faceplate away from camera case.

    • Damage to the connector line will prevent the on/off power switch's operational function.

    Modifier

  9. Olympus D590 Retainer Clip Replacement, Retainer Clip: étape 8, image 1 de 1

    • Orient the camera as shown, with the bottom facing up.

    • Open the retainer clip, by using your finger to push down and slide to the left.

    • The clip should pop open.

    Modifier

  10. Olympus D590 Retainer Clip Replacement: étape 9, image 1 de 1

    • Hold the retainer clip down (without re-latching it).

    • Use a flathead screwdriver to start to pry out the pin holding the retainer clip's spring to the camera.

    Modifier

  11. Olympus D590 Retainer Clip Replacement: étape 10, image 1 de 1

    • Use tweezers to continue to remove the pin.

    Modifier

  12. Olympus D590 Retainer Clip Replacement: étape 11, image 1 de 1

    • When it feels loose, pull the pin all the way out with your fingers.

    Modifier

  13. Olympus D590 Retainer Clip Replacement: étape 12, image 1 de 1

    • Once the pin comes out, the retainer clip, spring, and pin will no longer be attached to the rest of the camera.

    Modifier
Conclusion

To reassemble your device, follow these instructions in reverse order.

Auteur

avec 4 autres contributeurs

Katie

Membre depuis le 04/15/10

31 Réputation

3 tutoriels rédigés

Badges: 7

+ 4 badges supplémentaires

Équipe

Cal Poly, Team 28-23, Regan Spring 2010 Membre de l'équipe Cal Poly, Team 28-23, Regan Spring 2010

CPSU-REGAN-S10S28G23

4 membres

14 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 2,140