Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Pièces & Outils

Introduction

This guide will detail how to replace the circuit board that connects the tablet top with the keyboard base. If the base fails to connect to the tablet replacing this circuit board might solve the problem.

  1. Use a spudger to disconnect the black bundled cable connector from the motherboard. Use a spudger to disconnect the black bundled cable connector from the motherboard.
    • Use a spudger to disconnect the black bundled cable connector from the motherboard.

  2. Use a spudger to lift the black tab on top of the ZIF connector. Slide the ribbon cable out of the connector. Slide the ribbon cable out of the connector.
    • Use a spudger to lift the black tab on top of the ZIF connector.

    • Slide the ribbon cable out of the connector.

  3. Use a spudger to flip up the black retaining flap on the ZIF connector. Pull the folded ribbon cable straight out of the connector. This ribbon cable must be disconnected before removing the battery because it is attached to the battery with adhesive.
    • Use a spudger to flip up the black retaining flap on the ZIF connector.

    • Pull the folded ribbon cable straight out of the connector.

    • This ribbon cable must be disconnected before removing the battery because it is attached to the battery with adhesive.

  4. Fix Kits pour écrans LCD d'iPhone

    L'option économique couverte par notre garantie à vie.

    Acheter des kits

    Fix Kits pour écrans LCD d'iPhone

    Réduisez les coûts de réparation et non pas la qualité.

    Acheter des kits
  5. Use a spudger to pry the battery away from the device.
    • Use a spudger to pry the battery away from the device.

    • Always use ESD safe tools when working with delicate electrical components.

  6. Use tweezers to pull the dock contact display cable away from the connector on the motherboard.
    • Use tweezers to pull the dock contact display cable away from the connector on the motherboard.

  7. Use a Phillips #000 screwdriver to unscrew the two 4.2mm screws from the circuit board containing the dock contact.
    • Use a Phillips #000 screwdriver to unscrew the two 4.2mm screws from the circuit board containing the dock contact.

  8. Lift the dock contact assembly  away from the device.
    • Lift the dock contact assembly away from the device.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Taylor Bratsch

Membre depuis le 06/09/2016

4 290 Réputation

14 tutoriels rédigés

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 67