Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Boutique

Introduction

Pre-req for removing the faceplate from Optical Bay Enclosures #78, 79, 80

Pièces

Aucune pièce spécifiée.

  1. Remove the three 3.0 mm Phillips screws from the optical bay enclosure.
    • Remove the three 3.0 mm Phillips screws from the optical bay enclosure.

  2. Starting from the left edge, gently pull open the optical bay enclosure. Continue to pull open the two halves of the enclosure until they separate. Continue to pull open the two halves of the enclosure until they separate.
    • Starting from the left edge, gently pull open the optical bay enclosure.

    • Continue to pull open the two halves of the enclosure until they separate.

  3. Remove the two 3.0 mm Phillips screws securing the faceplate to the optical bay enclosure.
    • Remove the two 3.0 mm Phillips screws securing the faceplate to the optical bay enclosure.

  4. Lift the black plastic faceplate out of the optical bay enclosure. You will no longer need the faceplate or the two Phillips screws that held it in place. Set those parts aside if you ever wish to put the faceplate back into the enclosure. Reassemble the optical bay enclosure without the faceplate, reusing the original three 3.0 mm Phillips screws to keep it intact.
    • Lift the black plastic faceplate out of the optical bay enclosure.

    • You will no longer need the faceplate or the two Phillips screws that held it in place. Set those parts aside if you ever wish to put the faceplate back into the enclosure.

    • Reassemble the optical bay enclosure without the faceplate, reusing the original three 3.0 mm Phillips screws to keep it intact.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Brittany McCrigler

Membre depuis le 05/03/2012

85 365 Réputation

132 tutoriels rédigés

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 3

Total : 692