Introduction

This guide shows how to disassemble the Osram Lightify gateway.

  1. Remove the front using a metal spudger.
    • Remove the front using a metal spudger.

    • Once you can get your fingers in, remove the rest using your hand.

  2. On the back of the front cover, remove the white plastic using a metal spudger. Remove the PCB using a spudger
    • On the back of the front cover, remove the white plastic using a metal spudger.

    • Remove the PCB using a spudger

  3. %Livraison gratuite pour toute commande supérieure à 100 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique
  4. Once the PCB is removed, use a Torx T9 screwdriver to unscrew and remove the power supply. Remove the screws holding on the back cover with a Torx T9 screwdriver and remove the back cover.
    • Once the PCB is removed, use a Torx T9 screwdriver to unscrew and remove the power supply.

    • Remove the screws holding on the back cover with a Torx T9 screwdriver and remove the back cover.

    • all the screws are the same. they can be mixed with no problem.

  5. Remove the button by grabbing the tab over the button and pulling it out. it will not come out if the button is not depressed. Remove both metal sheets. when its at an angle, push it in a little and then pull it up so that it is pointing straight up. then, you can push it through.
    • Remove the button by grabbing the tab over the button and pulling it out.

    • it will not come out if the button is not depressed.

    • Remove both metal sheets. when its at an angle, push it in a little and then pull it up so that it is pointing straight up. then, you can push it through.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Aiden Baker

Membre depuis le 19/09/2015

11 857 Réputation

22 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 4

Total : 95