Aller au contenu principal

Introduction

Prerequisite only.

  1. Firmly grip your hand around the slot lever.
    • Firmly grip your hand around the slot lever.

  2. Stabilize the toaster by placing your hand on top.
    • Stabilize the toaster by placing your hand on top.

  3. Forcefully pull the slot lever away from the toaster by keeping parallel to the table. Forcefully pull the slot lever away from the toaster by keeping parallel to the table.
    • Forcefully pull the slot lever away from the toaster by keeping parallel to the table.

  4. Both slot levers can be removed.
    • Both slot levers can be removed.

  5. Batteries pour ordinateurs portables

    Une réparation facile pour un gain en puissance max.

    Acheter maintenant

    Batteries pour ordinateurs portables

    Une réparation facile pour un gain en puissance max.

    Acheter maintenant
  6. Place the toaster upside down so the bottom is facing the ceiling.
    • Place the toaster upside down so the bottom is facing the ceiling.

  7. Take off both rubber feet using a small metal spudger. Wedge a spudger under the feet and pull up to pop off.
    • Take off both rubber feet using a small metal spudger.

    • Wedge a spudger under the feet and pull up to pop off.

  8. Use a PH#2 screw bit to remove eight 12mm screws that are located around the perimeter.
    • Use a PH#2 screw bit to remove eight 12mm screws that are located around the perimeter.

    • There are two screws under the rubber feet.

  9. Place the toaster right side up.
    • Place the toaster right side up.

  10. Grab the outer shell firmly and pull up towards the face of the toaster. Grab the outer shell firmly and pull up towards the face of the toaster.
    • Grab the outer shell firmly and pull up towards the face of the toaster.

  11. For this part, you might need to wiggle the toaster to get the outer shell off.
    • For this part, you might need to wiggle the toaster to get the outer shell off.

    • The shell will not completely come off until the motherboard is removed in the next step.

  12. Use a J1 screw bit to unscrew eight 8mm screws from the motherboard. Use a J1 screw bit to unscrew eight 8mm screws from the motherboard. Use a J1 screw bit to unscrew eight 8mm screws from the motherboard.
    • Use a J1 screw bit to unscrew eight 8mm screws from the motherboard.

  13. Take out the grey “cancel” and “bagel” buttons from the shell. Take out the grey “cancel” and “bagel” buttons from the shell.
    • Take out the grey “cancel” and “bagel” buttons from the shell.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Melissa

Membre depuis le 12/09/2016

183 Réputation

1 tutoriel rédigé

Équipe

CSU Fullerton, Team 2-1, Bruce Fall 2016 Membre de l'équipe CSU Fullerton, Team 2-1, Bruce Fall 2016

CSUF-BRUCE-F16S2G1

5 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 117