PSP 1000 Front Casing Replacement

Introduction

This guide will show you how to remove the PSP's housing/frame.

Ce dont vous avez besoin

Étape 1 Battery

PSP 1000 Front Casing Replacement, Battery: étape 1, image 1 de 1

Turn the PSP over so its back is facing you.

Modifier

Étape 2

Locate the battery casing button on the rear-left side of the PSP.
Press down the button and remove the battery cover.

Modifier

You are dumbbb... BRO YOUR DUMB BC U DIDNT HAVE TO USE A TOOL TO OPEN THE DOOR. USE YOUR FINGER""

Paulo Moments - 2 mai 2023 Réponse

The battery door can be damaged dont use a tool

Paulo Moments - 2 mai 2023 Réponse

That also happend to me it got destroyed by screwdriver

Paulo Moments - 2 mai 2023 Réponse

Étape 3

Using your finger, remove the battery upwards from the system as shown.

Modifier

The use of the opening tool is completely unnecessary. There is a finger actuated opening latch button that says “PUSH” on it. Simply press down with your thumb then slide your thumb down and away, dragining the battery door with it. It will then come off. Assuming the system still has its original plastics, they may have become brittle enough that the opening tool could damage the release button or the plastic cover.

Franklin Allen - 8 août 2021 Réponse

Étape 4 Front Casing

PSP 1000 Front Casing Replacement, Front Casing: étape 4, image 1 de 2

PSP 1000 Front Casing Replacement, Front Casing: étape 4, image 2 de 2

Remove the four screws shown with a Phillips #00 screwdriver.
You will have to peel back the guarantee sticker to access the screw on the lower left.

Modifier

Much luck to you if you have a tiny, metal screwdriver like I did, the screws might be stuck in there and may require some force.

Squib - 14 août 2017 Réponse

you need to peel back the warranty sticker in order to access both the lower left and lower left screws

Frederick zzstu Geib - 18 mars 2020 Réponse

This is a bit misleading, you should only remove the two black screws in the battery compartment. The silver ones can stay.

Damian Cartwright - 21 oct. 2020 Réponse

The two left hand screws won’t come out of mine

XULF - 8 juin 2022 Réponse

iFixit screwdriver bits aren't thin enough to reach the two screws on the right near the memory stick slot.

Fliggle_Slaps - 20 janv. 2023 Réponse

Can't edit previous comment so here's a new one:

Standard or older iFixit screwdriver bits aren't thin enough to reach the two screws on the right near the memory stick slot. You'll need precision bits that have longer tips to reach these deep screws.

Fliggle_Slaps - 20 janv. 2023 Réponse

Étape 5

Remove the screw from the bottom side of the PSP. Keep it separated from the rest of the screws.
Remove screws from back righthand side within the holes.

Modifier