Introduction

Guide for removing the power board in a Sony PSP-3000

Place the PSP face down and locate the battery cover on the left side of the device.
  • Place the PSP face down and locate the battery cover on the left side of the device.

  • Lift and remove the battery cover to reveal the battery.

  • Remove the battery.

Ajouter un commentaire

Peel back the warranty sticker that is behind the battery with a spudger or your fingernail.
  • Peel back the warranty sticker that is behind the battery with a spudger or your fingernail.

Ajouter un commentaire

  • Unscrew all four screws from the back of the PSP with the Phillips #00 Screwdriver.

    • Two are located behind the battery's warranty sticker.

    • Two are located on the right side of the PSP.

Ajouter un commentaire

  • Next, unscrew the two screws located at the top of the PSP.

Ajouter un commentaire

  • Then, remove the single screw from the bottom edge of the PSP (which is positioned next to the barcode).

Ajouter un commentaire

  • Slide the spudger in between the outer casing of the PSP, beginning at the "R" shoulder button, and gently pry off the casing.


  • Remove the front casing completely.

Ajouter un commentaire

  • Push the homebar to the right to release the tab located on the right side of the LCD screen.

  • DO NOT completely remove the homebar, as it is still connected by ribbon cables.

Ajouter un commentaire

  • Slowly lift the LCD screen off the PSP starting at the top edge corner.

  • Again, the LCD screen is attached by ribbon cables, so do not remove it completely.

    • Orientation of PSP is flipped in photo.

Ajouter un commentaire

  • Flip the small brown locks on the four ribbon cable connectors up using a spudger or fingernail.

  • Pull all four ribbon cables out.

  • Now remove the LCD screen and homebar from the PSP.

Ajouter un commentaire

  • Remove the metal tab that lies above the LCD screen.

  • Upon reassembly, make note that the stamped lettering faces down, and the large tab fits just above the motherboard to the right hand side of the left trigger.

Ajouter un commentaire

  • Flip the lock and remove the ribbon cable from the power board.

Ajouter un commentaire

  • Remove the screw from the power switch board.

Ajouter un commentaire

  • Remove the power switch assembly/board.

Ajouter un commentaire

Ligne d'arrivée

mbnewsom

Membre depuis le 28/10/2009

2 372 Réputation

11 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 13

30 derniers jours : 69

Total : 11,083