Réparez vos affaires Communauté Boutique

Palm Centro Back Housing Replacement

Introduction

Follow this guide if you need to replace the back case of your Palm Centro or if you need to access the internals of your device.

Ce dont vous avez besoin

  1. Palm Centro Back Housing Replacement, Disassembling Palm Centro Battery: étape 1, image 1 de 2 Palm Centro Back Housing Replacement, Disassembling Palm Centro Battery: étape 1, image 2 de 2

    • Press and slide open the battery cover.

    Modifier

  2. Palm Centro Back Housing Replacement: étape 2, image 1 de 1

    • Caution: Turn cell phone off before removing battery!

    • Press battery to the right.

    • Then lift up battery pack to remove.

    Modifier

  3. Palm Centro Back Housing Replacement: étape 3, image 1 de 1

    • Phone with battery removed

    Modifier

  5. Palm Centro Back Housing Replacement, Back Housing: étape 4, image 1 de 1

    • Remove the touchpad pen from the top left corner on the back to reveal the last of 6 screws to be removed.

    Modifier

  6. Palm Centro Back Housing Replacement: étape 5, image 1 de 1

    • Lift the rubber cap at the top right to reveal the sixth screw.

    • Caution: There is a small Palm sticker under the rubber cap. Tampering with or removing this sticker will void your warranty!

    • Remove the six screws using the T5 Torx screwdriver.

    Modifier

  7. Palm Centro Back Housing Replacement: étape 6, image 1 de 2 Palm Centro Back Housing Replacement: étape 6, image 2 de 2

    • Remove the SIM card so housing can be separated.

    Modifier

  8. Palm Centro Back Housing Replacement: étape 7, image 1 de 2 Palm Centro Back Housing Replacement: étape 7, image 2 de 2

    • Use a plastic pry tool to separate the bottom of the case to remove the small plastic insert.

    Modifier

  9. Palm Centro Back Housing Replacement: étape 8, image 1 de 2 Palm Centro Back Housing Replacement: étape 8, image 2 de 2

    • Remove the small plastic insert at the bottom of the phone.

    Modifier

  10. Palm Centro Back Housing Replacement: étape 9, image 1 de 2 Palm Centro Back Housing Replacement: étape 9, image 2 de 2

    • Continue with plastic pry tool all the way around the phone to remove the back housing.

    Modifier
Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autres ont terminé cette réparation.

Auteur

avec 6 autres contributeurs

Chelsea Barackman

Membre depuis le 04/13/10

42 Réputation

3 tutoriels rédigés

Badges: 6

+ 3 badges supplémentaires

Équipe

Cal Poly, Team 15-49, Garner Spring 2010 Membre de l'équipe Cal Poly, Team 15-49, Garner Spring 2010

CPSU-GARNER-S10S15G49

5 membres

12 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 3

Total : 3,762