Aller au contenu principal

Introduction

Installing a new motherboard assembly which contains the processor and software package.

Pièces

Aucune pièce spécifiée.

  1. Place the Palm IIIx face down on a flat surface.
    • Place the Palm IIIx face down on a flat surface.

  2. Push down and lift up the battery cover to remove it.
    • Push down and lift up the battery cover to remove it.

  3. Remove the old batteries one at a time.
    • Remove the old batteries one at a time.

  4. Using a Phillips #00 screwdriver, remove the four screws that hold the back cover in place.
    • Using a Phillips #00 screwdriver, remove the four screws that hold the back cover in place.

  5. Batteries pour ordinateurs portables

    Une réparation facile pour un gain en puissance max.

    Acheter maintenant

    Batteries pour ordinateurs portables

    Une réparation facile pour un gain en puissance max.

    Acheter maintenant
  6. Hold the device on its side, positioning your hands as shown.
    • Hold the device on its side, positioning your hands as shown.

    • Remove the back cover by pushing in with your thumbs and pulling outward with the rest of your fingers.

  7. Hold the screen and front cover on its side, facing the screen inward as shown.
    • Hold the screen and front cover on its side, facing the screen inward as shown.

    • Position your hands so that you can push the screen outward with your thumbs.

    • Remove the screen by pushing outward with your thumbs. Use your index fingers to hold the front cover in place.

  8. Position the device with the screen facing down. Locate the white ribbon wire on the left hand side of the device.
    • Position the device with the screen facing down.

    • Locate the white ribbon wire on the left hand side of the device.

    • On either side of the ribbon wire are two white clasps. Gently push the two clasps away from the board (to the left).

  9. Detach the ribbon wire by gently pulling it out of its connector.
    • Detach the ribbon wire by gently pulling it out of its connector.

  10. Separate the motherboard from the screen.
    • Separate the motherboard from the screen.

  11. Now the motherboard assembly can be replaced successfully.
    • Now the motherboard assembly can be replaced successfully.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Ben Johnson

Membre depuis le 26/01/2010

22 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 14-43, Regan Winter 2010 Membre de l'équipe Cal Poly, Team 14-43, Regan Winter 2010

CPSU-REGAN-W10S14G43

4 membres

4 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 2

Total : 2,743