Introduction

This guide will walk you through the steps to remove the motherboard on a Palm T|X.

Orient the device so that the display faces forward. Remove the stylus from the right side.
  • Orient the device so that the display faces forward.

  • Remove the stylus from the right side.

Ajouter un commentaire

Turn over the device so that the back panel faces forward.
  • Turn over the device so that the back panel faces forward.

  • Use a T5 Torx screwdriver to remove the four 6.35mm corner screws.

Ajouter un commentaire

Rotate the device so that the display faces forward. Insert a plastic opening tool with the angled tip pointing downward into the crevice on the left side of the device.
  • Rotate the device so that the display faces forward.

  • Insert a plastic opening tool with the angled tip pointing downward into the crevice on the left side of the device.

  • Pry along the crevice to loosen the back panel.

  • Repeat this process for the right side.

Ajouter un commentaire

Carefully pry the back panel to open the device. Be careful not to break the wire that connects the battery pack to the motherboard.
  • Carefully pry the back panel to open the device.

  • Be careful not to break the wire that connects the battery pack to the motherboard.

  • When reassembling, snap the back panel back into place and then insert the top cover.

Ajouter un commentaire

Use a plastic opening tool to peel the battery pack from the back panel. The battery pack is glued to the back panel so removing it may require considerable effort.
  • Use a plastic opening tool to peel the battery pack from the back panel.

  • The battery pack is glued to the back panel so removing it may require considerable effort.

Ajouter un commentaire

Use a soldering iron to disconnect the battery wires from the motherboard. For soldering instructions, you can view the Soldering Guide.
  • Use a soldering iron to disconnect the battery wires from the motherboard.

  • For soldering instructions, you can view the Soldering Guide.

Ajouter un commentaire

Pull straight up on the ribbon cables located on the bottom right of the motherboard to disconnect them. Pull straight up on the ribbon cables located on the bottom right of the motherboard to disconnect them.
  • Pull straight up on the ribbon cables located on the bottom right of the motherboard to disconnect them.

Ajouter un commentaire

Lift the mother board out of the device. A weak adhesive attaches the motherboard to the device.
  • Lift the mother board out of the device.

  • A weak adhesive attaches the motherboard to the device.

  • The red wire in the picture will not be attached to your device at this point.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Spencer Lewson

Membre depuis le 19/01/2011

733 Réputation

6 tutoriels rédigés

Équipe

Cal Poly, Team 1-15, Amido Winter 2011 Membre de l'équipe Cal Poly, Team 1-15, Amido Winter 2011

CPSU-AMIDO-W11S1G15

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 1

30 derniers jours : 8

Total : 2,876