Réparez vos affaires Communauté Boutique

Palm m 100 Circuit Board Replacement

Introduction

This guide will provide instructions and visuals on how to replace a faulty circuit board.

Ce dont vous avez besoin

    • Remove the batteries.

    Modifier

    • Using a Torx 5 screwdriver, remove the four screws located on the rear cover of the device by turning counterclockwise. Set aside screws.

    Modifier

    • Remove rear cover by gently lifting it up from the bottom.

    Modifier

    • Carefully lift up the circuit board, which will also lift up the screen, so do so carefully to prevent breaking the connectors.

    Modifier

    • Lift the left side of the circuit board and open it as though it were a book.

    Modifier

    • Unplug the three connectors located on the right side of the circuit board with great caution and care. Do not pull by the cable and be sure to pull the connector itself gently.

    Modifier

    • After separating the screen from the board, set aside the faulty circuit board.

    Modifier

    • Replace with a new circuit board

    Modifier

    • Plug in the three connectors.

    Modifier

    • Close again like a book, and lay it gently into the front panel, screen facing outwards of the front panel.

    Modifier

    • Put the back cover on the device and screw the four screws, screwing in a clockwise direction. Take caution not to over-tighten the screws.

    Modifier
Conclusion

To reassemble your device, follow these instructions in reverse order.

Auteur

avec 5 autres contributeurs

Lexi Gallucci

Membre depuis le 10/18/11

11 Réputation

2 tutoriels rédigés

Badges: 4

+ 1 badge de plus

Équipe

James Madison, Team 1-3, Allen Fall 2011 Membre de l'équipe James Madison, Team 1-3, Allen Fall 2011

JMU-ALLEN-F11S1G3

5 membres

5 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 479