Introduction

If the front and/or rear cover is cracked, this guide will teach the user to remove the damaged cover and replace with a new one.

Pièces

Aucune pièce nécessaire.

  1. Remove the batteries.
    • Remove the batteries.

    Ajouter un commentaire

  2. Using a Torx 5 screwdriver, remove the four screws located on the rear cover of the device by turning counterclockwise. Set aside screws.
    • Using a Torx 5 screwdriver, remove the four screws located on the rear cover of the device by turning counterclockwise. Set aside screws.

    Ajouter un commentaire

    • Remove rear cover by gently lifting it up from the bottom. To remove the front cover, flip the device over, and then separate the screen/circuit board from the cover.

    Ajouter un commentaire

    • Set aside broken cover, and replace with a new cover.

    Ajouter un commentaire

    • Close again like a book, and lay it gently into the front panel. Make sure the screen is facing outwards of the front panel.

    Ajouter un commentaire

    • Put the back cover on the device and screw the four screws, screwing in a clockwise direction. Take caution not to over-tighten the screws.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Anne Carey

Membre depuis le 25/10/2011

1 Réputation

3 tutoriels rédigés

Équipe

James Madison, Team 1-3, Allen Fall 2011 Membre de l'équipe James Madison, Team 1-3, Allen Fall 2011

JMU-ALLEN-F11S1G3

5 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 5

Total : 466